Look by Antonio Estrada

Learn the Steps to create this look below!

Featured Products: artistrypro Clean Pallet Shampoo and artistrypro Base Coat Conditioner

Prep: Shampoo and Condition with artistrypro Clean Pallet shampoo and artistrypro Base Coat Conditioner.

Step 1: Section left from right with a center part. Section each side in half equally to create 4 total sections. At the front hairline, section out a small vertical section on both sides to shape into place.

Step 2: Starting on the right top section closest the center part, create a Dutch French braid. At the crown, begin three strand braiding leaving small sections of hair out on the left and right side of each rotation. Continue braid to occipital and tease to hold into place.

Step 3: Moving down, repeat movements to crown, Dutch French braiding towards the back. At the back, leave small sections of hair out, this time only from the inner side (right side) of the braid.

Step 4: Repeat movements on the opposite side. On the second braid leave small sections of hair out, this time only from the inner side (left side) of the braid.

Step 5: With remaining hair using a flat iron, curl the hair with artistrypro Avant-Guard Heat Protection & Finishing Spray. Tease the hair at the base for volume and support.

Step 6: Moving into the front profile, shape edges that were left out using a spoolie into an S-Shape pattern. Set with artistrypro Avant-Guard Heat Protection & Finishing Spray.

Back